This is a sample explanation showing the kind of help tutors give. It is not an answer from a specific tutor.
The explanation
The method of joints treats every joint of a truss as a point in equilibrium. Because truss members only carry axial force (tension or compression), each joint gives you two equations: ΣFx = 0 and ΣFy = 0.
Steps:
- Draw a free body diagram of the whole truss and find the support reactions using ΣFx = 0, ΣFy = 0 and ΣM = 0.
- Start at a joint with no more than two unknown member forces.
- Assume every unknown member is in tension (its force pulls away from the joint).
- Solve ΣFx = 0 and ΣFy = 0. A positive answer means tension; a negative answer means compression.
- Move to the next joint with two or fewer unknowns and repeat.
Example: A triangular truss has a pin support at A and a roller at C, 8 m apart. Joint B is 3 m above the midpoint of AC. A 10 kN load acts straight down at B. Find the force in each member.
Geometry: each sloping member runs 4 m across and 3 m up, so its length is √(4² + 3²) = 5 m. Its direction components are therefore 4/5 horizontally and 3/5 vertically.
Step 1: Reactions. The load is central, so by symmetry Ay = Cy = 5 kN upward. There is no horizontal load, so Ax = 0.
Step 2: Joint A (unknowns: F_AB and F_AC)
- ΣFy = 0: 5 + F_AB × (3/5) = 0, so F_AB = −8.33 kN
- ΣFx = 0: F_AB × (4/5) + F_AC = 0, so F_AC = −(−8.33 × 0.8) = +6.67 kN
Step 3: Results
- AB: 8.33 kN compression (negative, so the member pushes on the joint)
- AC: 6.67 kN tension
- BC: 8.33 kN compression, by symmetry
Check at joint B: the two sloping members each push up on B with a vertical component of 8.33 × 3/5 = 5 kN. Together that is 10 kN upward, which balances the 10 kN load ✓
Sense check: in a simple triangle like this, the top members are squeezed and the bottom chord is stretched, like a bow and its string. That matches the results.
Common mistakes:
- Starting at a joint with three or more unknowns. You only have two equations per joint.
- Switching sign conventions halfway. Keep assuming tension and let the sign tell you the answer.
- Forgetting to carry the sign of a solved force into the next joint's equations.
If you only need one or two members in the middle of a large truss, the method of sections is faster: cut through up to three members and take moments about a point where two of the unknown forces meet.
Up against a deadline? Next time you're stuck on engineering homework and short on time, post it on HomeworkHero with your deadline. There's no posting fee, you compare offers from tutors and choose who to work with, and your payment is held in escrow until you approve the work.
Topics
- truss analysis
- method of joints
- statics
- equilibrium
- engineering