Engineering · Sample answer
How do you find beam reactions and draw shear force and bending moment diagrams?
This is a sample explanation showing the kind of help tutors give. It is not an answer from a specific tutor.
The explanation
Example: A simply supported beam AB is 6 m long, with a pin at A and a roller at B. A 12 kN point load acts downward 2 m from A. Find the reactions and draw the shear force and bending moment diagrams.
Step 1: Support reactions
- Take moments about A (counter-clockwise positive): R_B × 6 − 12 × 2 = 0, so R_B = 4 kN upward
- Vertical equilibrium: R_A + R_B = 12, so R_A = 8 kN upward
- Check with moments about B: R_A × 6 = 12 × 4, so 48 = 48 ✓
Notice that the support closer to the load carries more of it.
Step 2: Shear force diagram (SFD)
Work from left to right. An upward force steps the shear up; a downward force steps it down.
- At A, the shear jumps up to +8 kN.
- From A to the load (0 to 2 m) there are no other forces, so shear stays at +8 kN.
- At the load, it drops by 12 kN: 8 − 12 = −4 kN.
- From the load to B (2 to 6 m) it stays at −4 kN.
- At B, the reaction steps it back up by 4 kN to 0 ✓
Step 3: Bending moment diagram (BMD)
The change in moment between two points equals the area under the shear diagram between them.
- At A, the moment is 0 (a pin cannot resist moment).
- From A to the load: area = 8 kN × 2 m = 16, so the moment rises in a straight line to 16 kN·m.
- From the load to B: area = −4 kN × 4 m = −16, so it falls back to 0 at B ✓
The diagram is a triangle with its peak, the maximum bending moment of 16 kN·m, under the load.
Rules that speed things up:
- Maximum moment occurs where shear is zero or changes sign. Here the shear changes sign under the load.
- Point loads make steps in the SFD and corners in the BMD.
- A uniformly distributed load makes the SFD slope in a straight line and the BMD curve (a parabola).
- For a simply supported beam, the moment is zero at both ends.
Common mistakes:
- Using the distance to the wrong support when taking moments.
- Not checking that the shear diagram closes to zero at the far end. If it doesn't, a reaction is wrong.
- Mixing sign conventions. Most courses treat sagging (the beam smiling) as a positive moment.
Up against a deadline? Next time you're stuck on engineering homework and short on time, post it on HomeworkHero with your deadline. There's no posting fee, you compare offers from tutors and choose who to work with, and your payment is held in escrow until you approve the work.
Topics
- shear force diagram
- bending moment diagram
- beam reactions
- statics
- engineering